Category Archives: Uncategorized

I’ve been lugging around these two 4×8 sheets of reconstituted ebony inspired particle board I won at a wood show years ago, three different houses later I’ve finally cut into one of them. I’ve decided to build a desk top … Continue reading →

Tonight with my 3D printer I printed out a cover plate that snaps into the side hole of my #festool #ts75 #tracksaw It drastically cuts down on the sawdust when cutting. #woodworking #ender3

I made these recently as gifts. First I glued up strips about 40 inches long of alternating colors of walnut and maple. The 2nd board is opposite colors. The 1st panel consist of the following strips:Walnut:• 3 mm – 1 … Continue reading →

I picked up a stump so I could put my anvil on but I had to flatten the top and bottom so everything would sit flat. Here’s how I did it. I shimmed the bottom so it would sit relatively … Continue reading →

3/3 of my new tools I got from my $500 gift prize from www.bridgecitytools.com. It’s a dual angle block plane with depth skids and has an included 90 and 45 degree fence. The blade has each end sharpened at a … Continue reading →

2/3 of my new tools I got from my $500 gift prize from www.bridgecitytools.com. It’s a multi-tool that has a flip down 90 degree marker, 8:1 dovetail and 6:1 dovetail markers. Also a cam-lock sliding t-bevel.

1/3 of my new tools I got from my $500 prize gift card I won at www.bridgecitytools.com. It’s a layout square, one side has a fixed 90 degree fence and the other side has an adjustable angle fence.

We were antique store hopping in this little town not far away and around the corner I saw a guy next to a pile of very large chunks of a maple tree that was taken down and cut up. I … Continue reading →

I found this at an auction, turns out it’s a popular model of small cnc. It’s a cnc 3018 pro. It wasn’t expensive compared to retail price I won it for but I’m sure I’ll find a use for it. … Continue reading →